Efco 147 Instruction Manual Page 21
- Page / 109
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
en
21
OPERATION
Work Area Precautions
WARNING: Cut only wood or materials made from
wood. Do not cut metal, plastics, masonry, or
non-wood building materials.
• Never allow children to operate your saw. Only allow others
to use this chainsaw who have read this Operator's Manual or
received adequate instructions for the safe and proper use of
this chainsaw.
• Keep everyone - helpers, bystanders, children, and animals
a safe distance from the cutting area (Fig. 44). During felling
operations, the safe distance should be a least twice the
height of the largest trees in the felling area. During bucking
operations, keep a minimum distance of 35 feet (10 m)
between workers.
• Always cut with both feet on solid ground to prevent being
pulled off balance.
• Do not cut above chest height, as a saw held higher is difficult
to control against kickback forces.
• Do not fell trees near electrical wires or buildings. Leave this
operation for professionals.
• Cut only when visibility and light are adequate for you to see
clearly.
• Do not cut from a ladder, this is extremely dangerous.
Leave this operation for professionals.
• Stop the saw if the chain strikes a foreign object. Inspect the
saw and repair parts as necessary.
• Keep the chain out of dirt and sand. Even a small amount
of dirt will quickly dull a chain and increase the possibility of
kickback.
• Stop the engine before setting the saw down.
• Be particularly cautious and alert while wearing hearing
protection because such equipment may restrict your ability to
hear sounds indicating danger (calls, signals, warnings, etc).
• Be extremely cautious when working on slopes or uneven
ground.
• When a chainsaw is being used, a fire extinguisher should be
available.
Starting The Engine
WARNING: Keep body to the left of the chain line.
Never straddle the saw or chain, or lean over past
the chain line. The chain brake must be engaged
when starting the saw.
• Place the chainsaw on level ground and ensure that no objects
or obstructions are in immediate vicinity which could come in
contact with the bar and chain. Hold the front handle firmly
with the left hand and put your right foot onto the base of the
rear handle, see Fig. 45.
• Set the chain brake by pushing the chain brake lever / hand
guard forward (towards the bar), to the Brake Position as
shown in Fig. 46. Refer to Safety-Chain Brake and Operation-
Chain Brake Sections for additional information.
44
46
45
35 ft
- THE OPERATOR’S MANUAL 2
- TABLE OF CONTENTS 3
- Chainsaw Components 4
- State and Local Requirements 5
- Understanding Safety Labels 5
- Basic Safety Precautions 7
- Fuel Handling 8
- Operation and Safety 8
- Precautions Against Kickback 9
- SAFETY RULES 10
- Maintenance Precaution 13
- ASSEMBLY 15
- Assembling the Bar and Chain 15
- OPERATION 17
- Chain Tension 17
- Breaking-in the Chain 17
- Bucking Spike 18
- Chain Oil System (Fig. 40) 19
- Preparation for Cutting 20
- Starting The Engine 21
- Ice Device System 22
- Breaking-in the Engine 23
- Stopping The Engine 23
- Chain Brake Operation 24
- Tree Felling 24
- Bucking 26
- Limbing and Pruning 27
- Maintenance Chart 29
- MAINTENANCE 30
- Chain Maintenance 30
- Guide Bar Maintenance 31
- Carburetor Adjustment 32
- Fuel Filter 32
- Air Filter 32
- Starter Unit 33
- Spark Plug 33
- Spark Arresting Muffler 33
- Chain Brake 34
- TROUBLESHOOTING 35
- Using Troubleshooting Chart 35
- IGNITION SYSTEM: 36
- MANUEL DE L'UTILISATEUR 37
- SOMMAIRE 38
- Composants de la tronçonneuse 39
- SÉCURITÉ 40
- RÈGLES DE SÉCURITÉ 42
- Précautions de base 42
- Manipulation du carburant 43
- Fonctionnement et sécurité 43
- Position Fonctionnement 46
- Position 46
- Précaution d'entretien 48
- FONCTIONNEMENT 51
- Tension de la chaîne 51
- Rodage de la chaîne 51
- Crampon de débitage 52
- Mélange essence/huile 53
- Préparation à la coupe 54
- Étraglement 56
- Systeme antigivre 57
- Rodage du moteur 57
- Abattage 59
- Débitage 61
- Ébranchage et élagage 62
- Tableau d'entretien 64
- ENTRETIEN 65
- Entretien de la chaîne 65
- Entretien du guide-chaîne 66
- Réglage du carburateur 67
- Filtre à carburant 67
- Filtre à air 67
- Démarreur 68
- Silencieux pare-étincelles 69
- Frein de chaîne 70
- DIAGNOSTIC DES PANNES 71
- REMISAGE 72
- CARACTÉRISTIQUES TECHNIQUES 72
- Remisage de la tronçonneuse 72
- MANUAL DEL OPERADOR 73
- ÍNDICE DE CONTENIDOS 74
- Componentes de la motosierra 75
- SEGURIDAD 76
- REGLAS DE SEGURIDAD 78
- Manejo del combustible 79
- Funcionamiento y seguridad 79
- Precauciones contra el rebote 80
- Precauciones de mantenimiento 84
- ENSAMBLAJE 85
- FUNCIONAMIENTO 87
- Tensión de la cadena 87
- Rodaje de la cadena 87
- Púa de tronzado 88
- Mezcla de combustible 89
- Preparación para cortar 90
- Funcionamiento 92
- Difusión 92
- Sistema antihielo 93
- Rodaje del motor 93
- Tala de árboles 95
- Tronzado 97
- Corte de ramas y poda 98
- Tabla de mantenimiento 100
- MANTENIMIENTO 101
- Mantenimiento de la cadena 101
- Ajuste del carburador 103
- Filtro de combustible 103
- Filtro de aire 103
- Unidad de motor de arranque 104
- Freno de la cadena 106
- SOLUCIÓN DE PROBLEMAS 107
- ALMACENAMIENTO 108
- DATOS TÉCNICOS 108
- ISO 9001 109
Related products and manuals for Power chainsaws Efco 147
Power chainsaws Efco 147 Instruction Manual
(37 pages)
(37 pages)
Power chainsaws Efco MT 3500 User Manual
(60 pages)
(60 pages)
Power chainsaws Efco MT4400 Specifications
(60 pages)
(60 pages)
Power chainsaws Efco MT 3500 Specifications
(60 pages)
(60 pages)
© 2020, manymanuals.com. All rights reserved. | 0.589 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals